The DJI Power 1000 Mini is fully compatible with all xTool laser engravers. It provides reliable power to ensure uninterrupted operation for your entire xTool ecosystem.

Runtime depends on customer traffic and your specific setup: For typical markets (steady traffic): Up to 33 hours for the xTool F2 alone, or 28 hours with the Desktop Smoke Purifier. For peak markets (back-to-back orders): Up to 30 hours (F2 alone), or 24 hours (F2 + Purifier).

The DC port is highly recommended. The F2 is a native DC device. While you can plug the F2's original power cable into the DJI's AC port, the power conversion causes minor battery efficiency loss. For maximum battery life and zero power loss, connect the F2 directly to the DJI's DC port using our custom DC-to-DC cable.

If you experience any quality issues with your product, please contact DJI Support directly via dji.com. DJI will take care of the subsequent service procedures. For non-quality issues, you are eligible for xTool's standard return policy, provided that the product's original packaging, accessories, gifts, and manuals are intact.

1. DO NOT store the power station for an extended period after fully discharging. Otherwise, the battery may over discharge and cause irreparable damage to the battery cell.
2. For long-term storage, it is recommended to maintain the procduct's battery level at 50% to 70% (ideally around 60%). Storing with high battery level for a long duration can cause the battery to age more quickly, while storing with low battery levels can cause over-discharge. It is recommended to checktthe battery level every 3 to 4 months during storage and recharge if necessary.
3. Then, recharge and discharge it once roughly every six months: First, discharge the power station to below 15% power off, and wait for two hours or longer. Then, recharge it to 100% using the Standard Recharge Mode in order to maintain the power station.